BlueTR3A-5EKT Posted August 1, 2023 Report Share Posted August 1, 2023 My handle is attached by stainless wood screws as the dash roll edge has timber in it. the shell is pre 60 k Be sure the screws are not too long. On post TS60k cars. To fit the U nuts to the dash edge structure the capping that covers the dash too needs removing. Quote Link to post Share on other sites
Charlie D Posted August 1, 2023 Report Share Posted August 1, 2023 4 hours ago, BlueTR3A-5EKT said: On post TS60k cars. To fit the U nuts to the dash edge structure the capping that covers the dash too needs removing. Peter, My car is TS51495 and does not have the wood, but has the slots cut out for the U nuts. (It does have the wood in the doors though, for the sidescreen mounts.) I wonder when the change actually occoured. Charlie. Quote Link to post Share on other sites
BlueTR3A-5EKT Posted August 1, 2023 Report Share Posted August 1, 2023 26 minutes ago, Charlie D said: Peter, My car is TS51495 and does not have the wood, but has the slots cut out for the U nuts. (It does have the wood in the doors though, for the sidescreen mounts.) I wonder when the change actually occoured. Charlie. Oh well there goes another piece of believed info. Maybe it was when the aeroscreen mount holes were deleted at circa 43k Quote Link to post Share on other sites
Chris Fleet Posted August 1, 2023 Report Share Posted August 1, 2023 I suppose there could have been various replacements/mods over the years by owners as well….. some investigation required Quote Link to post Share on other sites
Teher Posted August 2, 2023 Report Share Posted August 2, 2023 (edited) This is 2829 LO. It should be black… Edited August 2, 2023 by Teher Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.