marki Posted February 29 Report Share Posted February 29 Hi All. Well after fitting my glass into the Surrey this is what I’m left with. The seal,was from Moss but didn’t appear to be too long as I’ve heard they should be. Is it like this because the seal is too short ? cheers Mark Quote Link to post Share on other sites
roy53 Posted February 29 Report Share Posted February 29 i would say so see my photo in a previous post on this Stuart will have the best word on this. Roy Quote Link to post Share on other sites
stuart Posted February 29 Report Share Posted February 29 (edited) 2 hours ago, marki said: Hi All. Well after fitting my glass into the Surrey this is what I’m left with. The seal,was from Moss but didn’t appear to be too long as I’ve heard they should be. Is it like this because the seal is too short ? cheers Mark What was the rubber fit to the glass like before fitting? If there was any slack was it placed at the corners? Have you tried to flip the rubber out a bit and push it down to the corner? Is that a Honeybourne frame? Stuart. Edited February 29 by stuart Quote Link to post Share on other sites
marki Posted February 29 Author Report Share Posted February 29 It’s an original frame, and when the seal went on there was no slack left. mark Quote Link to post Share on other sites
stuart Posted February 29 Report Share Posted February 29 2 hours ago, marki said: It’s an original frame, and when the seal went on there was no slack left. mark I talked to Moss technical director while I was writing the above post,, his advice was take it out and check again for slack that should be located at the corners. Stuart. Quote Link to post Share on other sites
marki Posted February 29 Author Report Share Posted February 29 I’ll give it another go, thanks Quote Link to post Share on other sites
marki Posted March 5 Author Report Share Posted March 5 Well that’s another win for the forum, took the glass out fitted as per the advice you gave and hey presto. Quote Link to post Share on other sites
Drewmotty Posted March 5 Report Share Posted March 5 Congratulations Mark on fitting, removing and refitting the glass without breaking it……and getting it right in the end. :-) Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.