nigelcurry Posted October 28, 2022 Report Share Posted October 28, 2022 Hi does anyone know how to fit the hard rubber cover that fits over the clutch pedal mechanism on the bulk head? It’s hard and really inflexible thanks in anticipation nige Quote Link to post Share on other sites
bob-menhennett Posted October 28, 2022 Report Share Posted October 28, 2022 Nige Have you tried the old " hot water bath / soak " for rubber components. A piece of thick string , looped through the cover , loose ends tied to a screwdriver to pull on.Untie and remove string , once in situ. May need a first dummy run but a second dip in hot water will do no harm. Bob Quote Link to post Share on other sites
nigelcurry Posted October 29, 2022 Author Report Share Posted October 29, 2022 Nice one bob-menhenett will give that a go nige Quote Link to post Share on other sites
Keith Warren Posted October 29, 2022 Report Share Posted October 29, 2022 (edited) Nige Like Bob says need it warm but all ways a poor fit what I did was make a fork type piece out of stainless sheet to slide around the boot and hold in place with two of the bracket mounting bolts, photo might help below but has held in place now for fourty years. Keith Edited October 29, 2022 by Keith Warren Quote Link to post Share on other sites
nigelcurry Posted October 29, 2022 Author Report Share Posted October 29, 2022 All suggestions great fully received thanks lads Quote Link to post Share on other sites
SeanF Posted November 2, 2022 Report Share Posted November 2, 2022 Never been able to. It's sitting there on the lever but not connected to either end. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.