John Morrison Posted February 14, 2022 Report Share Posted February 14, 2022 Hi all, two quick questions for your TR6 folk. Latest thinking on mastic between raer wing and inner wing, I was thinking Black windscreen sealant. and I need to check wiper motor operation, on tghe bench, what goes where so to speak? Thanks John. Quote Link to post Share on other sites
stuart Posted February 14, 2022 Report Share Posted February 14, 2022 The non setting windscreen sealant is what I use John, Roger H would probably be able to tell you the wiring operation of the later motors Stuart. Quote Link to post Share on other sites
barkerwilliams Posted February 14, 2022 Report Share Posted February 14, 2022 John, Wipers this is a good description which may be what you need Just the first section. Alan Quote Link to post Share on other sites
RogerH Posted February 14, 2022 Report Share Posted February 14, 2022 Hi John, what do you actually need to know.? Roger Quote Link to post Share on other sites
BlueTR3A-5EKT Posted February 14, 2022 Report Share Posted February 14, 2022 Anything of use here ? Refers to Jag and MG but the motor is almost identical to TR6 TR7 TR8 Quote Link to post Share on other sites
BlueTR3A-5EKT Posted February 14, 2022 Report Share Posted February 14, 2022 Did you use 626716 'Everseal' washers under the plain washer against the panel to stop water ingress around the fixing? Quote Link to post Share on other sites
stuart Posted February 14, 2022 Report Share Posted February 14, 2022 41 minutes ago, BlueTR3A-5EKT said: Did you use 626716 'Everseal' washers under the plain washer against the panel to stop water ingress around the fixing? As they dont come in the fitting kits and theyre 55p each I go round each screw hole with the sealer and then clean up the excess squeezed out after tightening. No leaks like that. Stuart. Quote Link to post Share on other sites
John Morrison Posted February 14, 2022 Author Report Share Posted February 14, 2022 5 hours ago, RogerH said: Hi John, what do you actually need to know.? Roger How to bench test the motor John. Quote Link to post Share on other sites
RogerH Posted February 14, 2022 Report Share Posted February 14, 2022 Hi John, here is the wiring diagram http://www.advanceautowire.com/tr2506.pdf If you can bench test the motor with its switch then connect it as per the diagram and off you go. If you do not have the switch to hand then connect 12V to the Ref/Green and you should get slow speed. 12V to the Blue green will give a fast speed. The Brown Green wire is for the auto park. I have a diagram in the garage that I will get tomorrow to show the auto park wiring. Roger Quote Link to post Share on other sites
John Morrison Posted February 15, 2022 Author Report Share Posted February 15, 2022 Mnay Thanks, guys. John. 20 hours ago, RogerH said: Hi John, what do you actually need to know.? Roger Basically Roger, Want to test the original motor on the bench, before re-installation. John. Quote Link to post Share on other sites
RogerH Posted February 15, 2022 Report Share Posted February 15, 2022 Hi John, do as above. Roger Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.