colin3511 Posted September 1, 2019 Report Share Posted September 1, 2019 Hi, I know this is not uncommon. Any clever ideas to solve it please? Thanks Colin Quote Link to post Share on other sites
RogerH Posted September 1, 2019 Report Share Posted September 1, 2019 Hi Colin, tighten the nut at the top so it just pinches the stay Ensure the small piece of sponge is on the bracket on the wheel arch. Cover the rod with black heat shrink. Roger Quote Link to post Share on other sites
Rob Salisbury Posted September 1, 2019 Report Share Posted September 1, 2019 1 hour ago, RogerH said: Hi Colin, tighten the nut at the top so it just pinches the stay Ensure the small piece of sponge is on the bracket on the wheel arch. Cover the rod with black heat shrink. Roger +1 ..... Been there, done all that, it works!! Cheers Rob Quote Link to post Share on other sites
graeme Posted September 2, 2019 Report Share Posted September 2, 2019 (edited) Under the nut, there should be a waved washer part # 550026 which is NLA so I use a Thackery washer part # AJD7722 which helps to stop it rattling. Cheers Graeme Edited September 2, 2019 by graeme Spelling Quote Link to post Share on other sites
tr6tuga Posted September 3, 2019 Report Share Posted September 3, 2019 Besides all previous suggestions carefully check out the way it rests on the side, some bending usually is necessary, it did it in my case but it took more than a year to get it right... Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.