GT6M Posted December 4, 2018 Report Share Posted December 4, 2018 How t,split the rear bearings on a Spitty type using Alott of ..forgiving surfaces, he,hee,heeee, heeeeee, heeeeeeeeeeeeeee. Quote Link to post Share on other sites
Motorsport Mickey Posted December 4, 2018 Report Share Posted December 4, 2018 Ha Ha Haaaaaaaaaaaaa Now that is cheaper than a Gym membership ! I became worried when he knelt down, I thought he was praying ! Mick Richards Quote Link to post Share on other sites
Lebro Posted December 4, 2018 Report Share Posted December 4, 2018 There must be an easier way to chop up firewood Bob. Quote Link to post Share on other sites
GT6M Posted December 4, 2018 Author Report Share Posted December 4, 2018 there a wee pin in it, if he took that oot, then it,ll come of easier Butt, theee,s things are really hard on, like the rear drive stubs,or a Mini flywheel. think its aboot 40-60 ton they put on wid, M Quote Link to post Share on other sites
Drewmotty Posted December 4, 2018 Report Share Posted December 4, 2018 Timber takes the ballistic sting out of impacts. When removing TR hubs in a similar manner I use a piece of ally plate to protect things and keep the shock levels high. A bit of heat never goes amid either. Not too hot just enough so that you need gloves. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.