Jump to content

Phil Smith

Registered User
  • Content Count

    23
  • Joined

  • Last visited

Recent Profile Visitors

292 profile views
  1. Hi cheers I have no marks on pully so put paper plug into number 1 turned over slowly by hand plug poped out under compression. Then placed brass rod in number one and v slowly rotated untill vertical movement stopped marked pulley as Tdc. The router arm points slightly back from number 1 but not directly at it.
  2. Hi Just rebuilt 4a can't get engine to fire. Tdc on compression done good spark on all plugs firing order 1342, both fuel bowls on SU's have fuel, when put finger in main bodys feel wet with fuel. When turn car over on new battery nothing after 10 15 second crank. Tried start spray into still no fire all gaps on points and plugs good brand new. Rotary arm pointing at number 1 cylinder Funnily tried first thing there was a slight cough on initial turn of key from cold Then nothing, Run out of ideas
  3. OK thanks got it now cheers for your time
  4. Just had referb by Pete Cox not sure if I should use 2nd gear interlock as Pete has only replaced 3rd 4th interlock
  5. Yes sorry interlock switches
  6. Hi please could someone help have just installed my Jtype box into my 4a. I have wire harness from Moss, just want to confirm where the wire goes as the wiring diagram confused me. I belive the single yellow and purple wire attached to the selinod. The wire joins another yellow purple wire onto one spade not sure where that goes. There is then another double wire yellow and green onto another spade not sure where that goes. Two wires yellow and green and yellow and purple individual. Last single wire yellow and green with single push connector. Three relays on box two on the top one on
  7. Hi I've got Tr4a 65 in reconstruction it has main beam dip button on floor happy with that. Light switch on column was missing so I've just purchased new old stock steering column switch that clicks up and down once (side lights?) should I have on off switch on dash, not really sure what setup for this 4a is. Thanks Phil
  8. Phil Smith

    Philip

    Hi I have laycock tr6 J type gear box, trying to turn the main shaft but it turns slightly either way then stops against something. I can take out of gear and spin the propshaft end but main shaft again is locked. Put in gear can't turn propshsft end and can feel the movement on mainshaft but no turn. Have overdrive fitted, also had top plate off all looks good. Is it the overdrive unit stopping this via a clutch and how do I release cheers.????
×
×
  • Create New...

Important Information

Please familiarise yourself with our Terms and Conditions. By using this site, you agree to the following: Terms of Use.