Kevo_6 Posted February 9, 2023 Report Share Posted February 9, 2023 Hello. I have 3 or 4 small scabby rust holes in my rear right hand inner wing adjacent to the lamps. Rather than try and make some curved patch panels I thought I’d ask here first to see if any one has one of the inner wings lurking around. I’ve attached a photo of roughly the area that is needed. Many Thanks. Quote Link to post Share on other sites
BlueTR3A-5EKT Posted February 9, 2023 Report Share Posted February 9, 2023 (edited) As the stepped pocket is only required for the emission tank gubbins on NAS cars…..cut the whole lot out and fit a flat panel? You can use the LH side as a pattern. I’ll get my anorak Edited February 9, 2023 by BlueTR3A-5EKT Quote Link to post Share on other sites
Kevo_6 Posted February 9, 2023 Author Report Share Posted February 9, 2023 Thanks, I was actually thinking that but means a bigger welding job. I may go that way. Quote Link to post Share on other sites
elclem1 Posted February 9, 2023 Report Share Posted February 9, 2023 spot weld the flat panel not that much welding Quote Link to post Share on other sites
Kevo_6 Posted February 10, 2023 Author Report Share Posted February 10, 2023 16 hours ago, elclem1 said: spot weld the flat panel not that much welding Hi Clem, how would I spot weld it as I thought that a seam weld be better in that area? Quote Link to post Share on other sites
elclem1 Posted February 11, 2023 Report Share Posted February 11, 2023 You can seam weld but the bulge is spot welded i think so a flat piece of steel would be the same. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.