Mike JOnes Posted October 16, 2020 Report Share Posted October 16, 2020 Can anyone confirm what the torque setting for the flanges joining half shaft to diff are please? Thanks in anticipation Mike Link to post Share on other sites
Motorsport Mickey Posted October 16, 2020 Report Share Posted October 16, 2020 (edited) .. Edited October 16, 2020 by Motorsport Mickey Link to post Share on other sites
BlueTR3A-5EKT Posted October 18, 2020 Report Share Posted October 18, 2020 Single big nut holding flange to stub axle - 5/8" unf thread - tighten to 120 ft lbs. 4 hex head screws that hold assembled stub axle and the oil seal housing to the diff casing - 5/16" unf thread (1/2" A/F spanner) - 20 flt Lbs. Link to post Share on other sites
Mike JOnes Posted October 18, 2020 Author Report Share Posted October 18, 2020 thanks for that I was concerned about this as I was reading it as 100ftib from the manual which intuitively seemed too high Many thanks Mike Link to post Share on other sites
Recommended Posts