JohnG Posted May 16, 2016 Report Share Posted May 16, 2016 Ladies and Gents Is the air valve assembly screwed or pressed into the front inlet manifold? I would like to rotate the valve assembly in the manifold clockwise by about 30° If screwed, then, if I can get it out I can sort it out, but, if it is pressed in, I am not sure I have the kit to do it. As always, many thanks Quote Link to post Share on other sites
TR NIALL Posted May 16, 2016 Report Share Posted May 16, 2016 Pressed in. Quote Link to post Share on other sites
Richard71 Posted May 16, 2016 Report Share Posted May 16, 2016 Held fast by Araldite or the suchlike I think? Richard. Quote Link to post Share on other sites
JohnG Posted May 16, 2016 Author Report Share Posted May 16, 2016 Pressed in. bu99er Held fast by Araldite or the suchlike I think? Richard. bu99er again Many thanks both Quote Link to post Share on other sites
peejay4A Posted May 16, 2016 Report Share Posted May 16, 2016 (edited) Mine had worked adrift and it was easy enough to refit it with Araldite. If you're feeling lucky you could try jiggling it free with a pipe wrench then reposition with new Araldite. Edited May 16, 2016 by peejay4A Quote Link to post Share on other sites
JohnG Posted May 17, 2016 Author Report Share Posted May 17, 2016 Mine had worked adrift and it was easy enough to refit it with Araldite. If you're feeling lucky you could try jiggling it free with a pipe wrench then reposition with new Araldite. Pete Thanks I will give the assembly another, close look this week I'll let the forum know how I get on Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.