mike3md Posted March 7, 2014 Report Share Posted March 7, 2014 Dear All, There is a spring (missing on my TR4) between the cable assembly and the tunnel - item 36 on this diagram: http://www.moss-europe.co.uk/Shop/ViewProducts.aspx?PlateIndexID=1895 I now have the spring, and it appears to fit over the conduit in front of the grease point, but cannot figure out where it fits to the tunnel - is there supposed to be a small hole somewhere in the bottom seam? A picture or some measurements would be helpful. Thanks Mike Quote Link to post Share on other sites
Lebro Posted March 7, 2014 Report Share Posted March 7, 2014 I had the same problem on my '3, didn't fit it in the end 'cos the conduit was not in any danger of getting in the wrong place anyway. Bob. Quote Link to post Share on other sites
Kiwifrog Posted March 7, 2014 Report Share Posted March 7, 2014 On a 3A there is a small tab with a hole in it for the spring welded to floor, I think the 4 may be the same Cheers Alan Quote Link to post Share on other sites
mike3md Posted March 7, 2014 Author Report Share Posted March 7, 2014 The power of the Forum - 2 replies in 8 minutes! Lebro - I was wondering if it serves any useful purpose, possibly keeping it away from the fuel line (TR4)? Alan - The tab is missing on mine (probably lost in the rebuild) Mike Quote Link to post Share on other sites
pfenlon Posted March 7, 2014 Report Share Posted March 7, 2014 The fuel line is on the opposite side, I thin the spring was to keep the cable from hanging down and being snagged but I could be blagging here just a guess. Quote Link to post Share on other sites
Lebro Posted March 7, 2014 Report Share Posted March 7, 2014 Non original floors on my 3 so I guess that's why no tab with hole. Bob. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.