John h Posted May 30, 2020 Report Share Posted May 30, 2020 (edited) Hi to all hope everyone is well and staying safe can someone help me with some sizes please trying to fit the sill but with no lower inner rear wing and no bottom foot well bulkhead area all I’m doing when I try and lineup the bottom edge is push the upper flange in board if that makes sense what I need is a size between the two seals passenger-side driver-side so that I can then put some timber between gearbox flange and The Tunnel across the car also I’ve lined up the wings and on the very top edge of both wings at the door position I have a size of 888mm The door skin measures 875 giving me 13 mm for my gaps does that sound about right or a little bit too much perhaps the rear wing could move forward a fraction also while I’m on the rear wings fit flush with the decks yeah on the front wing What is the margin on the front wing top Edge as it meets inner wing I’m thinking about 3 mm is that about right kind regards John Edited August 31, 2020 by John h Remove Quote Link to post Share on other sites
Malbaby Posted May 30, 2020 Report Share Posted May 30, 2020 Off topic.....please advise where the sills were purchased. Quote Link to post Share on other sites
John h Posted May 31, 2020 Author Report Share Posted May 31, 2020 Tr shop London also supplied me with a good second hand A post regards John Quote Link to post Share on other sites
tr graham Posted May 31, 2020 Report Share Posted May 31, 2020 John at the point where the tunnel starts is 49&3/4” across the top outside edge to outside edge. same joint at the rear door top is 44&3/4” if you need any more I have a bare tub I am working on at present never been off the chassis and no repairs done or needed graham Quote Link to post Share on other sites
John h Posted May 31, 2020 Author Report Share Posted May 31, 2020 Thanks Grant that’s a great help Regards John Quote Link to post Share on other sites
John h Posted May 31, 2020 Author Report Share Posted May 31, 2020 Sorry Graham didn’t read it back Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.