Geko Posted June 1, 2019 Report Share Posted June 1, 2019 Gents, I seem to remember that the rear washer diameter (red arrow) is larger than the front to allow oil to flow around the bolt and feed the gauge through the banjo, is this correct ? Now I have plenty of copper washers of the same diameter but the only one that seem to fit the diameter requirement is not copper but soft composite material (see picture). Can anyone confirm/infirm that it's the correct washer or does it need to be copper? Thanks Quote Link to post Share on other sites
stuart Posted June 1, 2019 Report Share Posted June 1, 2019 It is large one first and they should really be copper. Stuart. Quote Link to post Share on other sites
peejay4A Posted June 1, 2019 Report Share Posted June 1, 2019 ...and you could anneal them first just to make sure they compress nicely for no leaks. Quote Link to post Share on other sites
Geko Posted June 10, 2019 Author Report Share Posted June 10, 2019 Alright, by accident i found that the above washer is for the block drain tap Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.