Nick Brooks Posted September 2, 2015 Report Share Posted September 2, 2015 Hi there, Does anyone know the recommended timing chain replacement interval for the 2138cc engine? I remember the duplex chain on a saab I had, was recommended at 100,000 miles, but that seems a lot for a TR engine! Thanks, Nick Quote Link to post Share on other sites
mike3md Posted September 2, 2015 Report Share Posted September 2, 2015 Nick, I think it's more a question of examining the condition of the chain and sprockets to decide if they need replacement. Mike Quote Link to post Share on other sites
AlanG Posted September 3, 2015 Report Share Posted September 3, 2015 You'll know when the tensioner wears out. Alan. Quote Link to post Share on other sites
Nick Brooks Posted September 4, 2015 Author Report Share Posted September 4, 2015 Thanks Mike for your feedback. Yes of course that is the best way. I changed my timing chain at 25,000 miles when doing an engine rebuild. I notice that the Haynes manual suggests changing at 30,000 miles. Quote Link to post Share on other sites
mike3md Posted September 4, 2015 Report Share Posted September 4, 2015 Nick, Oddly my (hardback) Haynes only has the same test of wear on the chain/sprockets as the WSM, i.e. that the chain should not be able to be pulled more than 0.4" (10mm) away from a straight edge between the sprockets. As Alan says, the tensioner needs to in good condition. Mike Quote Link to post Share on other sites
mike3md Posted September 4, 2015 Report Share Posted September 4, 2015 Whoops, just found that the Haynes does indeed suggest replacing at 30,000 miles! Not in the WSM though, and seems unduly cautious. Mike Quote Link to post Share on other sites
Nick Brooks Posted September 6, 2015 Author Report Share Posted September 6, 2015 Hi Mike, Yes I think it's rather cautious, I would have thought around 50,000 miles was more like it. Hunted around the Internet for opinions but to no avail. When I do come to replace it I notice that people are recommending Reynolds and German chains and tensioners and to avoid the Chinese products around. Thanks for your thoughts, Nick Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.