woodward Posted December 5, 2020 Report Share Posted December 5, 2020 Hi, I’m trying to wire in my hazard switch and looking for the double bullet connector with the feed (green wire) from the voltage stabiliser input and the output to the wipers and the flasher unit. Can somebody me let me know where this bullet connector is located in the car? Thanks Myles Quote Link to post Share on other sites
RAHTR4 Posted December 5, 2020 Report Share Posted December 5, 2020 Hi Myles, Go the Dip Switch and follow the wires, which should rise upwards, to its intersection with the main loom. At this location on the opposite side of the loom you should see one short green wire emerging and entering a bullet connector. Two other short green wires also emerge at this point and then enter the opposite end of the same bullet connector. One of these green wires then goes to the Flasher Unit and the second travels further to the Wiper Motor. I trust this helps, if not let me know and I will try to dig out a photo. Regards, Richard Quote Link to post Share on other sites
woodward Posted December 5, 2020 Author Report Share Posted December 5, 2020 Thank Richard. I see it now. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.