Richardtr3a Posted October 17, 2015 Report Share Posted October 17, 2015 I am fitting the timing chain cover soon. There is a stud through the cover in the middle. There seems to be some sort of washer or seal under the cover before the bolt goes on the outside to hold it all in. How should I seal this join. It is easy while the front panel is off and very tricky after full assembly. Any suggestions for any other improvements or maintenance, while I can reach easily, would be helpful Thanks, Richard (H is out) Quote Link to post Share on other sites
Fireman049 Posted October 17, 2015 Report Share Posted October 17, 2015 (edited) . Edited November 20, 2015 by Fireman049 Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.