Grinnal Posted May 29, 2014 Report Share Posted May 29, 2014 Hi, Found this useful diagram of where all the shims fit on a TR6 Chassis, hope it helps people Thanks Mike Quote Link to post Share on other sites
littlejim Posted May 29, 2014 Report Share Posted May 29, 2014 The Moss cattledog has a pretty good diagram for the lower numbered models. Quote Link to post Share on other sites
stuart Posted May 30, 2014 Report Share Posted May 30, 2014 Hi, Found this useful diagram of where all the shims fit on a TR6 Chassis, hope it helps people Thanks Mike It would be if it was correct but unfortunately its not even close for a standard nominal starting point. As LittleJim says the Moss book gives a much better diagram for use as a starting point but remember that is only a nominal starting point and you may have to adjust the amount of shims to allow for any anomalies in body or chassis alignment. Rule of thumb is start with the chassis level and then shim the body so it is then also level. Stuart. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.