littlejim Posted November 30, 2012 Report Share Posted November 30, 2012 recent test run to the coast and back seemed pretty warm despite it being an Oz summer. The investigation revealed the heater control stayed full ON irrespective of the knob position. Tried soldering (fail), then aralditing (fail) the outer cable to the knob cage. Eventually discovered that the wire that does all the work was thicker than the hole in the shaft the knob moves. It had nothing to do with the outer cable. Senior eyesight prolongs these discoveries. Had to drill out the hole in the shaft before the heater wire would go in far enough to get grabbed by the lock nut. Pretty small drill too. Luckily one that came with my arlec hand drill did the job. I'll get out of your way now. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.