ian l Posted November 7, 2012 Report Share Posted November 7, 2012 I have set the metering unit by getting no1 cylinder on tdc and looking down injector hole no6 on the metering unit. On doing this i have a full hole showing in the tube that turns in the metering unit Is this right? Ian Quote Link to post Share on other sites
badshead Posted November 7, 2012 Report Share Posted November 7, 2012 (edited) Ian Assuming no 1 is on firing stroke, a full hole is acceptable, but ideally you're looking for a cresent shaped hole in the range between the top and bottom illiustrations - see below Bill Edited November 7, 2012 by badshead Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.