tr3aproj Posted April 30, 2009 Report Share Posted April 30, 2009 In the process of restoring the folding seat on my TR3A. The pivot point I have found, is a 5/16 X 24 bolt that is brazed to the inside of seat bottom. Is this the factory method of creating the pivot point? Quote Link to post Share on other sites
TR 2100 Posted April 30, 2009 Report Share Posted April 30, 2009 (edited) In the process of restoring the folding seat on my TR3A. The pivot point I have founis a 5/16 X 24 bolt that is brazed to the inside of seat bottom. Is this the factory method of creating the pivot point? Yes (well, I don't know the thread, but that sounds right) It's not the sort of thing that gets changed. Then there was a chromed dome-headed bolt on the outside. PM me with your email address and I'll send you a photo. AlanR Edited April 30, 2009 by TR 2100 Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.