Tony Millward Posted September 12, 2008 Report Share Posted September 12, 2008 Hi all, I am about to weld a new lower wishbone bracket on my chassis but can't find any info on the spacing. The front brackets (in front of the spring) are fitted but I really need to know the distance between them. I checked with the other side but the spacing does not seem right (it's been repaired at some stage). Any advice would be appreciated. cheers Tony Quote Link to post Share on other sites
wheeler Posted September 12, 2008 Report Share Posted September 12, 2008 Tony Have a look at the TR6 Repair Operation Manual page 76.10.02 Sheet 2 where you will find a dimensioned drawing of the chassis but I am not sure if you can see a dimension for the bracket position though, think you will need a magnifing glass as the drawing is quite small! If you do not have this manual you will find a pdf version here http://www.vitessesteve.co.uk/PDF/TR6.pdf Hope this helps Cheers Bill Quote Link to post Share on other sites
Tony Millward Posted September 12, 2008 Author Report Share Posted September 12, 2008 Tony Have a look at the TR6 Repair Operation Manual page 76.10.02 Sheet 2 where you will find a dimensioned drawing of the chassis but I am not sure if you can see a dimension for the bracket position though, think you will need a magnifing glass as the drawing is quite small! If you do not have this manual you will find a pdf version here http://www.vitessesteve.co.uk/PDF/TR6.pdf Hope this helps Cheers Bill Thanks Bill, I do have that drawing but missed when I looked.. I measured the other side and plumped for 9.5", seems I was 0.03" out but should be ok. Ta Tony Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.