angelfj Posted December 5, 2007 Report Share Posted December 5, 2007 Can someone advise if these plastic vent knobs are available? Quote Link to post Share on other sites
Don Elliott Posted December 5, 2007 Report Share Posted December 5, 2007 Frank - I would use bit of epoxy on one and then clean both. Then I'd put them back on. I was missing one of these last year for the BRG TR3A that I was restoring and I bought a relic heater from a TR scrap-yard, refurbished the knob and put it on. Quote Link to post Share on other sites
angelfj Posted December 5, 2007 Author Report Share Posted December 5, 2007 Frank - I would use bit of epoxy on one and then clean both. Then I'd put them back on. I was missing one of these last year for the BRG TR3A that I was restoring and I bought a relic heater from a TR scrap-yard, refurbished the knob and put it on. good idea! did you paint the knob after the repair or did you try to match the colour of the epoxy? Quote Link to post Share on other sites
Lord Flashart Posted December 28, 2007 Report Share Posted December 28, 2007 I managed to find a whole new heater assembly on an old Landrover. I think it was a series one. I found that the TR part was stupidly expensive while the exact same part from a Landie was as cheap as chips! Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.