Jump to content

ChrisR-4A

TR Register Members
  • Content Count

    1,156
  • Joined

  • Last visited

Everything posted by ChrisR-4A

  1. Hi Andy there are some repairers who will replace the outriggers without lifting the body and this is done by cutting a part of the rear floor pan away to allow access to the area where the outrigger is welded to the top side of the main chassis rail. once welded in position the floorpan is bent back down and the cut is welded up. This type of repair is structurally sound and the welded floor is hidden by the mats, it also avoids the problem of alignment which can occur when the chassis and body are completly parted. The question is do you need to remove the body for any other reason, if no
  2. Hi Andy, best fit with no spacers are compomotive, some from Midland wheels appear ok depending on tyre size, not quite the same offset. My 4A has newish (4years) wires with 185x70x15 tyres, but if I did change I would go for the compomotives. You will sell your wires easier if you have the splined hubs to sell as well, and the short studs. Chris
  3. The centre locking minilites are quite heavy, and be carefull of cheap bolt ons, some of these will not fit without spacers and have an inferior finish, I know of two members who have tried these and returned them, the better ones have a more rounded profile. Unless your splined hubs are in very good condition I would remove them , fit new studs and buy standard bolt on minlites, you dont need to have a centrelocking spare then and you can use locking wheelnuts. Chris
  4. Hi Matthew, my 4A has the Moss slightly uprated and lowered springs all round, (no spacers req). They are a bit thicker than standard and about 1inch lower, I have the part numbers at home if you need them. I will email a photo. Chris
  5. Hi guys, when I purchased my 4A 10 years ago it had a bad oil leak from the bellhousing, investigations found the crankcase venting recirculating valve was in poor condition so on advice I removed it completly and vented the rocker cover direct to the atmosphere down below the carbs past the chassis. I also fitted the crankcase vent tube as used on tr4's which also vents direct and can be fitted with engine in place after removing the core plug. These mods stopped nearly all the leak , still a bit on some sump bolts but this has been reduced be removing bolts, cleaning with thinners and re
  6. New website run by East saxons member Chris Russell to show latest developments of the Breeze~Breaker wind deflector rear screen with lots of photos of members cars.
  7. Thanks for the info guys, I Have now cured the problem and the answer came from another Forum topic. It was the inlet/exhaust manifold nuts not being tight enough, I tightened them this evening and had the choke full off in under a mile best regards Chris
  8. My 4A is standard with CD175 carbs, except for an electric fan and electronic ignition. and has run fine for the last few years. However, since removing the cylinder head it has developed a warm up running problem. It starts ok with about 1 inch of choke but after 1/2 mile under load it appears to run lean if the choke is pushed in far and will not pull cleanly without some choke for about 3-4 miles. After this it runs fine, all the power and performance it always had and carries on ok all day. I have checked and ballanced the carbs, diaphrams, and recent new fuel pump. It's like it's dra
×
×
  • Create New...

Important Information

Please familiarise yourself with our Terms and Conditions. By using this site, you agree to the following: Terms of Use.