tr graham
-
Content Count
795 -
Joined
-
Last visited
Content Type
Profiles
Forums
Calendar
Posts posted by tr graham
-
-
£300K
-
Peter
Tr6 did not have chrome interior door handles ,
Graham
-
Chris
The genuine correct Timkin bearings are available from specialist bearing suppliers ,including the special differential ones , the correct ones are getting towards what you quoted , beware similar without the S at cheap prices from the usual suspects.
I have a complete correct set if you are looking .
Graham
-
Yes Mark typo error 1969
Graham
-
-
i have a very very nice TR5 steering wheel if any body is looking will be at stoneliegh
graham
-
Both good cars drove the cheaper one , prices are still creeping up
Graham
-
May I please advise any potential importer or purchaser of a SA car to contact the club before purchasing , as Getting a UK V5 from the DVLA is not straightforward with SA cars at present
V765 officer
-
chris
mike ellis would be the person to answer this question for you his mail details are tr2-3registrar@tr-register.co.uk
is there a reason you are asking ???
-
Stuart
Nearly impossible on an italia!!!
But just achievable with 1/4 drive from underside with car on a ramp
-
agreed the items pridewood has for sale , are never cheap ,but the one thing i can assure you of , is that they will be as described if not better , and the man is gentleman to deal with ,
graham
-
It can be done without removing dash or gauges using 1/4 drive sockets with flexi head not easy but can be done
Graham
-
As I said Hans Kooy did have some made , they did require chrome put where very good
Graham
-
Try Hans kooy
-
Clem
There are several other small differences , ashtray hole for 1
Graham
-
Early moss not available now
-
Conrad
Do not tell me a little snow is going to keep you from the chance of finding mooore gooodies
-
You should not need washers , I suspect your rivet gun is fouling the popper when pulling tight , slide a small BA nut down the rivet before you slide it in your gun , this will allow the gun to pull tight against the rivet head and not the popper , there are very few rivet guns with a small enough head to go inside a popper and if they do it often cracks the plastic popper.
Graham
-
26/61969
Supplied by Cleveland motors
Cash price £1471 -11'-5.
-
Try checking the voltage when cranking the engine over it should go up if it's a CR car and will require a ballast resisted coil
As well
-
Been restored just an above average tr5 with a special number plate
-
go for it conrad
all the wheels look to be in the right position
-
bill
are you talking 4 terminal against 3 as per tr5 try checking E bay seller blowyourhorn from newark notts he normally has the correct ones
-
stuart
1 for a 5 and pair for a 250 , i have an original if you ever need one for a pattern , same material as boot board possibly a bit thicker
graham
1959 steering wheel
in TR6 Forum
Posted
Gary
Yes it’s still around , will be at stoneliegh if that helps