Graze Posted September 15, 2015 Report Share Posted September 15, 2015 (edited) I changed out the choke cable last weekend. All went well except in removing the switch plinth a couple of the ignition wires came loose. Replaced them and car ran normally Until I switched the side lights and head lights on Panel lights work when sidelights on but not when headlights on Checked wiring diagrams and all looks to be right Any ideas what I've done All help appreciated Graze Edited September 15, 2015 by Graze Quote Link to post Share on other sites
RogerH Posted September 16, 2015 Report Share Posted September 16, 2015 Hi Graze, when the headlights are on do the side lights go OUT as well. Roger Quote Link to post Share on other sites
Graze Posted September 16, 2015 Author Report Share Posted September 16, 2015 Good question, will check, thanks Roger Quote Link to post Share on other sites
Graze Posted September 16, 2015 Author Report Share Posted September 16, 2015 Roger They do indeed go out when headlights come on What have I got crossed up Graze Quote Link to post Share on other sites
RogerH Posted September 17, 2015 Report Share Posted September 17, 2015 Hi Graze, from this circuit diagram http://www.advanceautowire.com/tr24a.pdf Power goes to the light switch pin 4. The side lights power comes out of pin 7. Headlights power comes out of pin 8. Check the pull switch wiring. This switch is similar to the TR4A wiper motor switch. It is possible to connect to the (extra) wrong tags and still appear to work (but they don't). Roger Quote Link to post Share on other sites
Graze Posted September 17, 2015 Author Report Share Posted September 17, 2015 Thanks Roger The RG was on the wrong terminal Graze Quote Link to post Share on other sites
RogerH Posted September 17, 2015 Report Share Posted September 17, 2015 Success Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.