Prefect Posted June 20, 2022 Report Share Posted June 20, 2022 Would someone check the depth of nut in mm holding the rear hub on an IRS car. Quote Link to post Share on other sites
brenda Posted June 20, 2022 Report Share Posted June 20, 2022 Hi is this what you need, Mike redrose group Quote Link to post Share on other sites
harrytr5 Posted June 20, 2022 Report Share Posted June 20, 2022 There are two sizes that I know of one is 8.65 mm and the other is a full nut 10.98mm in depth. I always use the 8.65mm which leaves the correct 1-2 threads showing after torquing up 16lbs Regards Harry Quote Link to post Share on other sites
stuart Posted June 20, 2022 Report Share Posted June 20, 2022 Just now, harrytr5 said: There are two sizes that I know of one is 8.65 mm and the other is a full nut 10.98mm in depth. I always use the 8.65mm which leaves the correct 1-2 threads showing after torquing up 16lbs Regards Harry Wrong nuts Harry. Peter is on about the main hub nut. Stuart. Quote Link to post Share on other sites
harrytr5 Posted June 20, 2022 Report Share Posted June 20, 2022 Sorry I thought is was the six 5/16" nuts holding the hub on not the main one on the stub axle. Regards Harry Quote Link to post Share on other sites
harrytr5 Posted June 20, 2022 Report Share Posted June 20, 2022 Thanks Stuart, think I am going nuts! Regards Harry Quote Link to post Share on other sites
RogerH Posted June 20, 2022 Report Share Posted June 20, 2022 .........................what do you mean 'going' Roger Quote Link to post Share on other sites
Prefect Posted June 20, 2022 Author Report Share Posted June 20, 2022 Many thanks for your replies. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.