Jump to content

Recommended Posts

I am assembling my rear axle which is now shiny black. I took the half shaft out this afternoon to remove the backplate. But I noticed that there was some minor damage at the spot where the seal is in constant contact. This happen before on the LHS and I fitted a Speedi sleeve and it never failed again.

Does any one know the correct part number for the SKF special seal. I also do not remember how to slide it so far down the half shaft when the fitting kit only allows about two inches. I may need a long tube unless there is some other answer.

I am planning to buy from Simply Bearings but I need the correct part number.

Thanks for a part number.

Richard and B.

Link to post
Share on other sites

I have a length of scaffold tube that does the job ok for me.


Edited by BlueTR3A-5EKT
Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...

Important Information

Please familiarise yourself with our Terms and Conditions. By using this site, you agree to the following: Terms of Use.