rjs993 Posted October 3, 2021 Report Share Posted October 3, 2021 Help! When I removed the lower wishbone nearest the bulkhead (passenger side - RHD car) I discovered that there are TWO thrust washers fitted next to each other. This was a surprise as I expected one as had been the case on the other wishbone (on that side). Anyone any idea why this would be? Thanks Robert Quote Link to post Share on other sites
Malbaby Posted October 3, 2021 Report Share Posted October 3, 2021 Probably there to achieve good castor for wheel alignment. Quote Link to post Share on other sites
stuart Posted October 4, 2021 Report Share Posted October 4, 2021 10 hours ago, Malbaby said: Probably there to achieve good castor for wheel alignment. Wont make any difference on a 4. Stuart. Quote Link to post Share on other sites
rjs993 Posted October 4, 2021 Author Report Share Posted October 4, 2021 Thanks for the feedback. Makes sense. So, presumably it is best to leave things as they are? Should I expect the other side to be set up in the same way? Thanks again. Robert Quote Link to post Share on other sites
stuart Posted October 4, 2021 Report Share Posted October 4, 2021 Just now, rjs993 said: Thanks for the feedback. Makes sense. So, presumably it is best to leave things as they are? Should I expect the other side to be set up in the same way? Thanks again. Robert Refit it the correct way according to,the book unless you can find a real reason its been done. Stuart. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.