Jump to content

Accelerator pedal lever assy


Recommended Posts

Hi 

Have had a problem with the pin holding the lever assembly on to the accelerator pedal

rod , it is a new type cotter pin easy to remove, it kept lifting. On inspection the holes on the

lever assy are not lined up through the middle of the round section ( part no. 106753 ), so the pin

will not go all the way through. Does anybody have a spare one. If not will it be possible to weld one 

hole up and redrill.

Any solution appreciated.

Alan

 

Link to post
Share on other sites

It would be easy to weld up and redrill but obviously you would need to make sure that the angle of the arm is correct when you redrill.

Stuart.

Link to post
Share on other sites

Roll pins are available in larger sizes. Knock out the old pin (it may have broken) drill out a size larger and fit a larger roll pin

In emergency you can always push a bit of a drill, but it needs to be stronger than a nail

Don't ask me how I know

Michael

Link to post
Share on other sites

Have solved it similar to what you suggested Michael but got away with just drilling the pedal shaft

a shade bigger. As the roll pin is held by the lever holes that did not affect the tightness too much

and the extra movement allowed the pin to go through .

Thanks for the suggestions

Alan

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

Please familiarise yourself with our Terms and Conditions. By using this site, you agree to the following: Terms of Use.