Roger B Posted July 26, 2021 Report Share Posted July 26, 2021 carburettor floatsĀ Quote Link to post Share on other sites
Lebro Posted July 26, 2021 Report Share Posted July 26, 2021 What about them ? Quote Link to post Share on other sites
BRENDA1 Posted July 26, 2021 Report Share Posted July 26, 2021 They float in petrol! Mike redrose groupĀ Quote Link to post Share on other sites
Jase Posted July 26, 2021 Report Share Posted July 26, 2021 Is this like a Miranda thread, in entertaining words - Splodge! Quote Link to post Share on other sites
BlueTR3A-5EKT Posted July 27, 2021 Report Share Posted July 27, 2021 Is this a subtle trick to subvert 'the last person to post wins' ? Quote Link to post Share on other sites
keith1948 Posted July 28, 2021 Report Share Posted July 28, 2021 Hello Roger After contacting you directly I understand you have purchased some new stay up floats because your old ones began to sink because of a pinhole. The question was how to set float height. I am assuming this is for Strombergs. Invert the carbs and the highest part of the float when the needle is against its seating should be 18.5mm or 0.73 inch. I made a tool out of a bit of perspex to do this accurately. This is best described as E shaped but with the centre bit cut off (making a square U shape). The ends rest on the body of the inverted carb and the cutout is exactly 18.5mm. Easier than using a ruler. I would post a photo but computer says I need to delete some old photos to clear space. Good luck Keith Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.