Andy Moltu Posted April 30, 2021 Report Share Posted April 30, 2021 Had “fun” removing the ali’ bungs from the ends of the oil gallery. Before putting the new ones in I thought I might run a tap up them to make sure the threads are clean for the benefit of whoever gets to remove them next time. Anyone know what the thread size is? Quote Link to post Share on other sites
Lebro Posted April 30, 2021 Report Share Posted April 30, 2021 Not sure, but make sure they are sealed in. I used a strong locktite, 680 I think, to seal & to make sure it stays put. Bob Quote Link to post Share on other sites
Andy Moltu Posted May 2, 2021 Author Report Share Posted May 2, 2021 Took a punt on a 3/4 unf tap and now the bungs enter properly. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.