NCS_TR3A Posted February 16, 2021 Report Share Posted February 16, 2021 OK after taking the gearbox off I've now removed the flywheel and this is the picture - Clearly the seal is leaking. Actually a little surprised to see oil coming from where the two scroll half's join. Potentially how sealant used when fitting them. I now need to think how I'm going to get the engine out. I do have an RSJ across the roof and block and tackle but it would need the car to move rather than the engine and hoist moving around. Not that easy to push etc so will think about it before committing to a method. Neil Quote Link to post Share on other sites
Lebro Posted February 16, 2021 Report Share Posted February 16, 2021 Yes, there should have been sealant between the two halves, & they should be squeezed against each other. one or the the other was omitted it would seem. Bob. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.