MTY Posted January 23, 2021 Report Share Posted January 23, 2021 Dear all, I'm in the process of rebuilding the hardtop of my TR6. I have some questions about correct location/placement of several seals. In the pictures that I find on the internet, same seals often seem to be put on in different ways. Would someone perhaps have detailed pictures of the original way the seals are put on the hardtop? Specifically, it concerns the seals outlined in red on the added picture. Seal 23: Where exactly does it need to be cut on the vertical side at the bottom? Seal 24: Where is it to be cut to smoothly join the draught excluder of the side window? Seal 25: How does it fit correctly? Seal 26: What is the correct position of this one? Seal 27: Is the longer side of the seal on the outer side or on the inner side? Many thanks for your help. Kindest regards, Marc Quote Link to post Share on other sites
cord Posted January 24, 2021 Report Share Posted January 24, 2021 Hello Marc Did my HT refurb' recently. Lots of pictures and help out there, but found the original fitting instructions for the seals helpful.. as per attached section. Read it a few times, until clear :-) Dan Quote Link to post Share on other sites
MTY Posted January 25, 2021 Author Report Share Posted January 25, 2021 Hello Dan, Thank you very much for your answer. It was very helpful. I found the fitting instructions. Thanks again. Marc Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.