pfenlon Posted January 13, 2021 Report Share Posted January 13, 2021 I cannot fit it for the bulb holder is touching the stiffener bracket that goes from the top of the bulkhead to the steering column support bracket just being the dash. the stiffener is about 7"long cranked at both ends one hole is elongated the other not (which goes at the top?) is there a Spacer needed somewhere folks, i have tried with 2 types of bulb holder ??? I have used 3 nuts as a spacer but guessing. nothing shown in the manual. Quote Link to post Share on other sites
RogerH Posted January 13, 2021 Report Share Posted January 13, 2021 Hi Pete, that stack of nuts as a spacer doesn't look right. Roger Quote Link to post Share on other sites
pfenlon Posted January 13, 2021 Author Report Share Posted January 13, 2021 Its one of many ways I tried Roger?? maybe the spacer goes before the bracket at the top?? Pete. Quote Link to post Share on other sites
qkingston Posted January 13, 2021 Report Share Posted January 13, 2021 The top half of that bracket over the column should be fitted the other way round I believe so the flange is closer to the stay, you shouldn't need the space nuts then Rgds David Quote Link to post Share on other sites
Geko Posted January 14, 2021 Report Share Posted January 14, 2021 (edited) The rod should be bolted somewhere else on the plenum chamber for it should not be in the way of the bulb holders. Rotate the end of the rod clockwise and you'll probably find another threaded hole to align the rod eye with Edited January 14, 2021 by Geko Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.