Jump to content

Bullet Connector Location

Recommended Posts

Hi, I’m trying to wire in my hazard switch and looking for the double bullet connector with the feed (green wire) from the voltage stabiliser input and the output to the wipers and the flasher unit.  Can somebody me let me know where this bullet connector is located in the car?  



Link to post
Share on other sites

Hi Myles,

Go the Dip Switch and follow the wires, which should rise upwards, to its intersection with the main loom.

At this location on the opposite side of the loom you should see one short green wire emerging and entering a bullet connector.

Two other short green wires also emerge at this point and then enter the opposite end of the same bullet connector.

One of these green wires then goes to the Flasher Unit and the second travels further to the Wiper Motor.

I trust this helps, if not let me know and I will try to dig out a photo.

Regards, Richard


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...

Important Information

Please familiarise yourself with our Terms and Conditions. By using this site, you agree to the following: Terms of Use.