Jump to content

Recommended Posts


This is a vinyl trimming kit available from the usual suppliers. Mine came from the TR Shop and was very good. The vertical pieces that you refer to are easily made from very thin aluminium. Have attached some images. Hope they help.




Link to post
Share on other sites

Hi Eddie

Tims picture shows perfectly the fitting of the trim as he says you can easily make the two small side panels I used the the off white lightly embossed headlinning vinyl on mine you only need 1/2 meter(its 137cm wide) as its more than enough and a lot cheaper also used when replaced the main headlinning so matches


Link to post
Share on other sites

The side pieces not only need to be thin as Stef points out but they also need a waste edge at the front that is glued round the front lip then its covered and held in by the upright door rubber.


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...

Important Information

Please familiarise yourself with our Terms and Conditions. By using this site, you agree to the following: Terms of Use.