Adam Blackaby Posted November 1, 2020 Report Share Posted November 1, 2020 I am finally finishing off the installation of an overdrive g'box to Liz's TR4. Its only been over 18 months in the planning!! Can anyone advise as to the positioning of the switch operating relay, the workshop manual just casually says 'mount under dash facsia' If it makes any difference, car is LHD. Many thanks in advance for any guidance. Adam Quote Link to post Share on other sites
RogerH Posted November 1, 2020 Report Share Posted November 1, 2020 Hi Adam, for a RHD car the relay fits somewhere just above the dip switch hanging down from the underside of the battery compartment. It s pretty close to where the OD wires come out of the tunnel. I'm sure it would fit on the left side of the tunnel also. Roger Quote Link to post Share on other sites
Quicksilver Posted November 1, 2020 Report Share Posted November 1, 2020 (edited) Adam see this post, Marcel. Edited November 1, 2020 by Quicksilver Quote Link to post Share on other sites
Quicksilver Posted November 2, 2020 Report Share Posted November 2, 2020 this is the location in our TR4 LHD Quote Link to post Share on other sites
stuart Posted November 2, 2020 Report Share Posted November 2, 2020 40 minutes ago, Quicksilver said: this is the location in our TR4 LHD Essentially the same position regardless of left or right hand drive. Stuart. Quote Link to post Share on other sites
tthomson Posted November 3, 2020 Report Share Posted November 3, 2020 +1 for Stuart's reply Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.