pfenlon Posted April 18, 2020 Report Share Posted April 18, 2020 Could anyone post a pic of a bare RHD TR4 bulkhead, showing the standard holes. my LHD has too many extra holes, and a pic would be gratefully received TIAdvance Quote Link to post Share on other sites
BRENDA1 Posted April 18, 2020 Report Share Posted April 18, 2020 Peter if you look under the Tr4 section I think it’s the third page look for wiring loom there is a bulkhead that may help you out. Mike Redrose Group Quote Link to post Share on other sites
BRENDA1 Posted April 18, 2020 Report Share Posted April 18, 2020 Peter also page 9 left to right conversion bulkhead holes. Mike Redrose Group Quote Link to post Share on other sites
rcreweread Posted April 18, 2020 Report Share Posted April 18, 2020 (edited) Pete - I think Mike might be referring to a response I did previously - I've also attached some additional photos which I did specifically for recording what went where and in what holes for my own benefit which I'm sure I previously posted somewhere but I can't find where so have reposted here - however bear in mind this is a 4A shell, not a 4 but I don't think there are many differences. If there is a specific area giving you cause for concern, let me know as I do also have a bare TR4 front end, but it's not easy to get at, and I'll try and get some photos ! Link to post Cheers Rich Edited April 18, 2020 by rcreweread improve format Quote Link to post Share on other sites
pfenlon Posted April 19, 2020 Author Report Share Posted April 19, 2020 Thanks for your help with my post, it was very helpful. Best Pete Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.