AarhusTr6 Posted March 31, 2020 Report Share Posted March 31, 2020 good morning all I am doing a bit of a clean up on my hood and I'm unsure if I have put the rubbers in the right way around does this look correct in the picture? also are the rubbers trimmed to the length of the channel or is there a slight overhang?? Quote Link to post Share on other sites
Charlie D Posted March 31, 2020 Report Share Posted March 31, 2020 Hello, Not sure of your specific situation, but I’ve always found that if you fit a rubber strip into any sort of channel there is always a good chance of stretching it a bit. If you cut it off flush as soon as you fit it then it’s quite likely to shrink back after a few weeks and then it will be too short. Personal advice would be to fit it and leave it a while before you do any cutting, (If needed.) Charlie. Quote Link to post Share on other sites
AarhusTr6 Posted April 1, 2020 Author Report Share Posted April 1, 2020 (edited) thanks can anybody else have a quick look at their car and tell me if I have put them in the right way around because it does not look quite right to me!! Edited April 1, 2020 by AarhusTr6 Quote Link to post Share on other sites
Steves_TR6 Posted April 1, 2020 Report Share Posted April 1, 2020 Thats the way i fitted mine, same as was on previously. the lip outwards to ‘seal’ against the window steve Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.