Jump to content

World Bonnet badge


Recommended Posts

Measuring an old one I have - the distance between the 2 pins is 61mm centre to centre. The pins are 2.6mm in width - probably a 3mm hole will do the trick. the fitting holes are vertical. 

IMG_2445 (1).jpg

Link to post
Share on other sites

Ah, ok. Bottom hole on my bonnet is about 123 mm from the leading edge. My original 'world' badge was completely shot, and to be honest I've alway preferred the 'shield' from the 4 - but is expensive so went for a much cheaper generic 'shield' from a Vitesse / GT6. Hole spacing was different to the 'world', so I kept the lower hole, filled the upper one, and drilled a new (slightly) lower hole for the top badge pin.

IMG_3138.JPG

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

Please familiarise yourself with our Terms and Conditions. By using this site, you agree to the following: Terms of Use.