Phil Read Posted December 14, 2019 Report Share Posted December 14, 2019 Could anyone give me the exact dimensions/placement for fitting the world bonnet badge on a TR4A. Quote Link to post Share on other sites
rogerowen Posted December 15, 2019 Report Share Posted December 15, 2019 Measuring an old one I have - the distance between the 2 pins is 61mm centre to centre. The pins are 2.6mm in width - probably a 3mm hole will do the trick. the fitting holes are vertical. Quote Link to post Share on other sites
Phil Read Posted December 16, 2019 Author Report Share Posted December 16, 2019 Hi thanks for thet. There are no holes in the bonnet so it is the bonnet location measuremnt I need as I need to know where to drill the holes. Quote Link to post Share on other sites
rogerowen Posted December 16, 2019 Report Share Posted December 16, 2019 Ah, ok. Bottom hole on my bonnet is about 123 mm from the leading edge. My original 'world' badge was completely shot, and to be honest I've alway preferred the 'shield' from the 4 - but is expensive so went for a much cheaper generic 'shield' from a Vitesse / GT6. Hole spacing was different to the 'world', so I kept the lower hole, filled the upper one, and drilled a new (slightly) lower hole for the top badge pin. Quote Link to post Share on other sites
Phil Read Posted December 16, 2019 Author Report Share Posted December 16, 2019 Thanks for that, I will get drilling. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.