PodOne Posted October 16, 2019 Report Share Posted October 16, 2019 I used a "ball" the other side of an old alternator pully made out of the remains of an knackered rear drop link, Drilled it through and cut it off worked fine. Nice bit of upcycling if I say so myself Quote Link to post Share on other sites
Tim T Posted October 16, 2019 Report Share Posted October 16, 2019 This works well. Just make sure that you get the correct size ball! Tim Quote Link to post Share on other sites
Lebro Posted October 16, 2019 Report Share Posted October 16, 2019 Looks like a ball from the 3 point lift on a tractor Bob. Quote Link to post Share on other sites
Tim T Posted October 16, 2019 Report Share Posted October 16, 2019 Spot on, it is. Tim Quote Link to post Share on other sites
Z320 Posted October 16, 2019 Report Share Posted October 16, 2019 My first one, still in use but not pretty, was brass from a 3/4" heating ball valve from the scrap. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.