Jump to content

Brake Caliper Seal fitting 73 TR6


Recommended Posts

I'm refitting the brake caliper seals in the TR6 and should have paid closer attention while dissembling.  I've notice the cross-section profile of the ring gasket has one higher inside diameter edge rather than a straight forward rectangular shape; that is it has a peak on one side.   I'm thinking the higher edge goes toward the outer side of the caliper, toward the brake fluid pressure, with the lower edge permitting in and out movement.  

Have I got this correct?

Thanks

Cross-section.pdf

Edited by stillreel
Clarity
Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

Please familiarise yourself with our Terms and Conditions. By using this site, you agree to the following: Terms of Use.