Bfg Posted June 29, 2021 Author Report Share Posted June 29, 2021 12 hours ago, ntc said: Good luck with red poly bush’s Ok, thanks.., but just a tad more information might be helpful. Pete Quote Link to post Share on other sites
stuart Posted June 29, 2021 Report Share Posted June 29, 2021 25 minutes ago, Bfg said: Ok, thanks.., but just a tad more information might be helpful. Pete Too hard a compound for road use really, red is normally race, yellow fast road and blue standard road. Some manufacturers also use orange. careful selection of hardness is essential. Stuart. Quote Link to post Share on other sites
Bfg Posted June 29, 2021 Author Report Share Posted June 29, 2021 Just a few more . . . All looking good to me.. Pete. Quote Link to post Share on other sites
BlueTR3A-5EKT Posted June 29, 2021 Report Share Posted June 29, 2021 Have you got the brass threaded bit for the speedo cable angle drive to screw onto? Peter W Quote Link to post Share on other sites
Bfg Posted June 29, 2021 Author Report Share Posted June 29, 2021 1 hour ago, stuart said: Too hard a compound for road use really, red is normally race, yellow fast road and blue standard road. Some manufacturers also use orange. careful selection of hardness is essential. Stuart. Thanks ntc and Stuart, The poly suspension bushes were on the car as fitted by the prior owner. Supplied by TRGB they are listed on the invoice as Poly44. Mark has reused them but has replaced the bolts. A new sleeve was required for one side trailing arm where the old bolt had seized in, but otherwise as the car was before. Pete. Quote Link to post Share on other sites
Bfg Posted June 29, 2021 Author Report Share Posted June 29, 2021 7 minutes ago, BlueTR3A-5EKT said: Have you got the brass threaded bit for the speedo cable angle drive to screw onto? Peter W yes, ^ ..from when we replaced the clutch and its release mechanism. I was then looking into fitting the steel gearbox cover. Even then the right-angle drive necessitates a localised bulge in that cover. A more compact connection / change in direction would be nice. Pete. Quote Link to post Share on other sites
BlueTR3A-5EKT Posted June 29, 2021 Report Share Posted June 29, 2021 Will the early car set up work? Cable comes straight out through the cover, then down through the floor looping forward up to and through the bulkhead to the speedo. Cable is 84” long instead of 69” Quote Link to post Share on other sites
stuart Posted June 29, 2021 Report Share Posted June 29, 2021 1 hour ago, BlueTR3A-5EKT said: Will the early car set up work? Cable comes straight out through the cover, then down through the floor looping forward up to and through the bulkhead to the speedo. Cable is 84” long instead of 69” Only if you cut a hole in the floor, bit of a backward step really. Stuart. Quote Link to post Share on other sites
Bfg Posted June 29, 2021 Author Report Share Posted June 29, 2021 There's a small screwed-on panel which fits over the 90-degree angle drive, and although it bulges out an inch or so under the carpet - it's not worth changing for the sake of replacing it with another (custom made) cable cover. Pete. Quote Link to post Share on other sites
roy53 Posted June 30, 2021 Report Share Posted June 30, 2021 On 6/29/2021 at 10:58 AM, BlueTR3A-5EKT said: Will the early car set up work? Cable comes straight out through the cover, then down through the floor looping forward up to and through the bulkhead to the speedo. Cable is 84” long instead of 69” What car was that fitted to Pete ? never seen it but always learning. Roy Quote Link to post Share on other sites
BlueTR3A-5EKT Posted June 30, 2021 Report Share Posted June 30, 2021 6 hours ago, roy53 said: What car was that fitted to Pete ? never seen it but always learning. Roy The view is TR4. Carry over from TR2/3 Quote Link to post Share on other sites
Bfg Posted July 2, 2021 Author Report Share Posted July 2, 2021 Quick update from Mark on Tuesday .. Body tub back on and I'm told all the body-mount holes lined up beautifully ..and with even shimming its sitting nicely square. Oh dear, Katie looks to have lost a lot of weight. ^ Doors being fitted and carefully aligned. I'm to give Mark a call this morning, and hopefully he'll share further news of excellent progress. Pete Quote Link to post Share on other sites
Hamish Posted July 2, 2021 Report Share Posted July 2, 2021 this brill news and mark and his team seem to be very good with good comms which is nice to see. H Quote Link to post Share on other sites
Bfg Posted July 2, 2021 Author Report Share Posted July 2, 2021 2 minutes ago, Hamish said: this brill news and mark and his team seem to be very good with good comms which is nice to see. H Very much so, being able to talk and discuss things make the world of difference to a customer. I'm old fashioned enough to very much disliked self check-out tills at supermarkets, buying things from companies whose reception is an on-screen catalogue, who either have no contact number or else only call-centre agents in a different country, &/or where providers (banks to utility companies to government departments) provide 'a facility' rather than service, and their terms are inflexible to customer preferences. And I'm equally put off going to a pub and now only being able to order by app and not seeing, let alone speaking to, the landlord or bar staff. So dealing with Mark, and his being willing to talk whenever I needed to, has actually been a relative joy ('relative' only because I had a broken chassis and still have a bill to pay ). Indeed, throughout this - I don't recall one occurrence where I've had to wait for the phone to be answered for more than half a minute, when he has been unavailable, when I've been put on-hold, transferred to another department or agent ..and had to repeat everything again. I've not had to open an account, think up yet another pass-word, nor even give my date-of-birth. When was the last time you phoned a company and been greeted, in a cheerful voice, by the owner / partner who knows exactly what the status of the work is ..not even a file to be opened or to be looked up. And yet with M&T this has happened every time I've called. Good comms is intrinsic to good service, and that is becoming rare. Quote Link to post Share on other sites
Hamish Posted July 2, 2021 Report Share Posted July 2, 2021 i love my local bolt shop for that a trade counter where i can seek the advice of a man in a brown coat who knows his stuff and doesn't mind me taking in nuts and bolts for comparison with a stock of ancillaries from thread lock to work light torches etc https://threadfast.co.uk/ Quote Link to post Share on other sites
Charlie D Posted July 2, 2021 Report Share Posted July 2, 2021 4 hours ago, Bfg said: I'm old fashioned enough to very much disliked self check-out tills at supermarkets, buying things from companies whose reception is an on-screen catalogue, who either have no contact number or else only call-centre agents in a different country, &/or where providers (banks to utility companies to government departments) provide 'a facility' rather than service, and their terms are inflexible to customer preferences. And I'm equally put off going to a pub and now only being able to order by app and not seeing, let alone speaking to, the landlord or bar staff. So dealing with Mark, and his being willing to talk whenever I needed to, has actually been a relative joy ('relative' only because I had a broken chassis and still have a bill to pay ). Indeed, throughout this - I don't recall one occurrence where I've had to wait for the phone to be answered for more than half a minute, when he has been unavailable, when I've been put on-hold, transferred to another department or agent ..and had to repeat everything again. I've not had to open an account, think up yet another pass-word, nor even give my date-of-birth. When was the last time you phoned a company and been greeted, in a cheerful voice, by the owner / partner who knows exactly what the status of the work is ..not even a file to be opened or to be looked up. And yet with M&T this has happened every time I've called. Hello Pete, If ever they do a new series of “Grumpy Old Men” I’ll put your name forward. Charlie. Quote Link to post Share on other sites
Richmac Posted July 2, 2021 Report Share Posted July 2, 2021 Really pleased to see your car coming together so quickly for you and looking good. Hope you can soon enjoy it again knowing the chassis is solid as well as all the other areas that have now had a good inspection. I've read your posts and know your bank balance has taken an unexpected battering but I hope you we soon recover from this and can enjoy owning a special car again. All the best going forward Richard Quote Link to post Share on other sites
Bfg Posted July 2, 2021 Author Report Share Posted July 2, 2021 1 hour ago, Charlie D said: Hello Pete, If ever they do a new series of “Grumpy Old Men” I’ll put your name forward. Charlie. Hey less of the old .. around here I'm merely a kid . . . but yeah definitely grumpy .. and with one foot still firmly in the 20th century. Quote Link to post Share on other sites
Bfg Posted July 2, 2021 Author Report Share Posted July 2, 2021 1 hour ago, Hamish said: i love my local bolt shop for that a trade counter where i can seek the advice of a man in a brown coat who knows his stuff and doesn't mind me taking in nuts and bolts for comparison with a stock of ancillaries from thread lock to work light torches etc https://threadfast.co.uk/ Likewise Suffolk Fasteners here in Ipswich. Quote Link to post Share on other sites
harlequin Posted July 2, 2021 Report Share Posted July 2, 2021 For the last few days I have been helping my son on his house rebuild, this morning we ran out of screws so I volunteered to go to Screwfix. No need said one of the other blokes we can pop along to the shop in the village. Imagine my surprise it was a proper nut and bolt shop tucked away in the back of an industrial estate, I have lived here for 10 years and didn't have a clue it was there. Brilliant! George Quote Link to post Share on other sites
Bfg Posted July 3, 2021 Author Report Share Posted July 3, 2021 Friday update from Mark and his Team . . . ^ drain pipe fitted and led through the front wheel-arch splash closure. x4 wing fitting kits include new bolts, the correct clip-nuts & seals. ^ Door hanging and panel alignment, relative to the sill and each other. The check strap has been replaced and it now clicks to hold the door open. That's a nice bonus ^ Chassis rear legs are sitting evenly level, both relative to datum floor and to the rear valance panel. I might add that a whole bundle of work has happened ..but was barely noticed or reported on, such as correctly greasing each suspension and steering pivot and their reassembly with new bolts ..fitted with coppaslip. Similarly refitting the whole IRS drive-train and the brakes happened in a blink - even though the cut-short wire-wheel studs were replaced, which necessitated the brake calipers coming off. Those have of course been refitted as have the hydraulic systems. And when did any of those jobs just take five-minutes ! ? All in all steady progress has, and is constantly being made, but most of that work is in the smaller details. I'm really glad to have a conscientious mechanic, who is experienced with TR's, ensure things are in both good order and done correctly. Bidding you a good weekend, Pete. Quote Link to post Share on other sites
BRENDA1 Posted July 3, 2021 Report Share Posted July 3, 2021 Afternoon Pete, that’s really coming on now and is looking good, all you have to do is keep up the good work when you get her back ( which I know you will ) and you’ll be up and running in no time. We’re out for a 200 + mile run tomorrow but looks like it will be a little damp but it will wash Brenda. Mike Redrose Group Quote Link to post Share on other sites
stillp Posted July 3, 2021 Report Share Posted July 3, 2021 They seem to be doing a very nice job - I'm surprised we haven't heard more about that firm. Pete Quote Link to post Share on other sites
PodOne Posted July 3, 2021 Report Share Posted July 3, 2021 Hi Pete Been following this thread and there is some good great work been done to revive your pride and joy! Your going to have a cracking car back to enjoy. Keep the updates coming! Andy Quote Link to post Share on other sites
Mk2 Chopper Posted July 4, 2021 Report Share Posted July 4, 2021 The picture updates must be very reassuring that the job is being done right and they can be entrusted with your prize possession. I feel they will gain some work through this forum after people see what they are capable of. Looking forward to the next update. Gareth Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.