Wanted

[roy53]

I require  a pair of front over riders with support bars.

A metal glove box lid for a LH drive dash.

Also how does the choke cable fit carb end on stromberg carbs set up.

if only i had taken photo's

 

ROY

[signalredshaker]

These pictures should be of some help. Cable enters boss and there the outer cable ends- inner cable continues to square shaped projection on carburettor casting (the one with small hole) - cable then held tight by screw through the latter projection. Make sure carb moving bits are well lubricated and free of any drag. Good luck!

[rcreweread]

Roy - I sent you emails with photos of the stays and over riders  - I haven't had a response so did you not get them?

Cheers

Rich

[roy53]

On 4/15/2019 at 7:53 PM, rcreweread said:

Roy - I sent you emails with photos of the stays and over riders  - I haven't had a response so did you not get them?

Cheers

Rich

No not received yet Rich

[rcreweread]

Can you PM me your email to confirm I got it correct

Cheers

Rich 

[roy53]

On 4/15/2019 at 6:54 PM, signalredshaker said:

These pictures should be of some help. Cable enters boss and there the outer cable ends- inner cable continues to square shaped projection on carburettor casting (the one with small hole) - cable then held tight by screw through the latter projection. Make sure carb moving bits are well lubricated and free of any drag. Good luck!

many thanks for the photos  ,   now sorted

Roy