Jump to content

Recommended Posts

I bought a stainless steel exhaust manifold while at Stoneleigh, my cylinder head has been ported hence the manifold doesn't quite match up, I'll have to remove some material from the port flanges on the manifold. I thought I might do the job with a Dremel, can anyone advise on which attachment(s) I should buy?

Richard.

Link to post
Share on other sites

I'm still up at Stoneleigh, but if no-one has replied by the time I get back tomorrow I'll send you details of what I use, but a Dremel is a bit too lightweight to do any serious metal sculpting of the ports.

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

Please familiarise yourself with our Terms and Conditions. By using this site, you agree to the following: Terms of Use.