sheldricka Posted January 27, 2019 Report Share Posted January 27, 2019 Would someone mind confirming the correct route for the lamp cables to the loom. Mine are currently through the boot board clip hole! Quote Link to post Share on other sites
colin3511 Posted January 27, 2019 Report Share Posted January 27, 2019 Should go inside the rear valance and out of a hole on the centre line of the rear bumper Quote Link to post Share on other sites
sheldricka Posted January 27, 2019 Author Report Share Posted January 27, 2019 So the red cables from the loom runs between the inner and outer balance skin and out to the bumper lamp? Assume it enters this by a gap I’ve seen by the back of the light? Mine currently as you see goes via the inside of the boot straight through both skins via grommets and out on the centre line Quote Link to post Share on other sites
RogerH Posted January 27, 2019 Report Share Posted January 27, 2019 Make sure that ALL the body holes that the loom goes through has a grommet r other protection. The above picture is a recipe for a loom fire. Roger Quote Link to post Share on other sites
stuart Posted January 27, 2019 Report Share Posted January 27, 2019 It should go between the skins and out the back panel if it has the plate light on the bumper, there shouldnt be a hole in the boot floor, its a fiddle to get through so use a draw wire bent so it curves in from the outside and attach the wire to it and then draw back out. Stuart. Quote Link to post Share on other sites
sheldricka Posted January 28, 2019 Author Report Share Posted January 28, 2019 Perfect thanks. I’ll get that sorted out. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.