DaveN Posted November 29, 2018 Report Share Posted November 29, 2018 I just overhauled the front suspension and as part of that installed Mr.Moss’s uprated axle/bearings/hubs. All went well until the last one, the damn bearing wouldn’t fit on the axle. Could I get the blighter out, could I hell, I even tried swearing at it! In the end I had to take the assembly to Moss so they could press it out. A 20 tonne press later it finally yielded.... after pushing the nut down the thread! It had only been installed a couple of days.......Cold welded! The axle was 0.003 oversize. Moral.....trial fit first before committing! TRrials and TRibulations! Quote Link to post Share on other sites
JochemsTR Posted December 1, 2018 Report Share Posted December 1, 2018 I hope Moss took corrective action so we finally get rid of these quality issues....I do not understand why such "easy" parts cannot be made to print... Jochem Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.