Jump to content

Front chassi suspension brackets


Recommended Posts

Hi all

yet another question folks.

Just tacked some new brackets on after repairing the frame, the old brackets had peeled and split the top of the rails.

While I was at it I've welded a spreader plate to the sides where the strengthener brackets from Rimmers need to be welded the problem is that if they go on at 90 degrees the suspension brackets are slightly wider than the new brackets and hit the plates, also the smaller of the two seems too high and I suspect will foul the arm bolts. So even with the arms fitted to the brackets I'm not sure they will fit.

Anyone had this issue or do you fit them at an angle and cut down the smaller front bracket to fit?

Am I correct in thinking its the front holes that the brackets bolt up to? 

Cheers

Andy

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

Please familiarise yourself with our Terms and Conditions. By using this site, you agree to the following: Terms of Use.