ed_h Posted November 18, 2018 Report Share Posted November 18, 2018 I'd wager that the PDWA was leaking from the switch port, so the screw and the bolt were expedients to try to stop the leak. If you want to restore the warning light function, I'm afraid you'll have to take the PDWA out and rebuild it. There were two versions of the internal shuttle. One is trivial to rebuild, but the other has a seal that can be difficult or impossible to get. Ed Quote Link to post Share on other sites
AarhusTr6 Posted November 19, 2018 Author Report Share Posted November 19, 2018 Hi So maybe underneath the crew is the shuttle . . just did not want to go much further on this when I saw it. What a bodge job. Quote Link to post Share on other sites
Waldi Posted November 19, 2018 Report Share Posted November 19, 2018 Hi Richard, there should not be a screw, so hopefully the shuttle is there. I would remove the entire pdwa thing, dismantle, clean and inspect. I had the one with 2 o-rings on the shuttle, ordered new from Moss and it works ok. Waldi Quote Link to post Share on other sites
AarhusTr6 Posted November 19, 2018 Author Report Share Posted November 19, 2018 Hi Waldi Also guessed screw was not correct! I think I will take it out and also have a good look the whole device. Rich Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.